Cable Leader - 14 AWG Shielded Computer Power Cord Replacement, 3-Prong NEMA 5-15P to IEC C13, 15A 125V for PC, Monitor, Audio Amp - Black
Model: PW179-12XX
SKU: 13220006
Reviews coming soon
Reviews coming soon
Need a replacement power cord for a PC, monitor, or audio amp that sits next to audio or network cables? This Cable Leader 14 AWG shielded computer power cord is a standard 3-prong AC power cable with a NEMA 5-15P plug for any 120V outlet, power strip, or UPS and an IEC C13 connector for the C14 inlet on your device, rated 15A at 125V for up to 1875W. A grounded shield, bonded to the ground pin by a drain wire, wraps all three conductors to help keep the cord's electrical noise out of nearby cables, inside a black SJT jacket with molded ends and UL Listed construction. A universal power cord for any device using an IEC C14 inlet, including PCs, monitors, printers, projectors, powered speakers, and amps. Best for: a computer cord, monitor cord, or amp power cord in a crowded desk, rack, or AV cabinet, or a high-wattage PC power supply (PSU). Not for: fixing ground-loop hum, 2-prong devices, C7 figure-8, C5 cloverleaf, or C20 inlets, 240V circuits, or outdoor use. RoHS compliant.
Power cords and signal cables usually share the same tight space behind a desk, rack, or AV cabinet. This cord adds a grounded shield: a shield layer wraps all three conductors, and a drain wire bonds it to the ground pin at both ends, helping contain the electrical noise an unshielded cord gives off near audio, video, and network cables. It still works as a direct replacement for any standard 3-prong computer cord.
Three 14 AWG copper conductors are rated for a 15 amp load at 125 volts, up to 1875 watts, which is 50 percent more current than a typical 10A 18 AWG computer cord. That headroom suits 1000W-plus PC power supplies, workstations, 3D printers, and higher-power audio amps. UL Listed construction, manufactured to RoHS environmental standards.
Compatible with any device using an IEC C14 inlet. Quick check: desktop PC, monitor, or printer with a 3-pin C14 inlet - Yes; guitar or audio amp, powered speaker, or projector with a C14 inlet - Yes; C7 figure-8 or C5 cloverleaf laptop charger - No; C20 high-current inlet - No, it needs a C19 cord. For loads under 10A, our 18 AWG shielded C13 cord is the lighter option.
The black SJT jacket is VW-1 flame-rated and rated to 105°C, yet flexible enough to route behind a desk, through rack cable management, or into an AV cabinet. Both the NEMA 5-15P plug and the C13 connector are molded over the terminations for strain relief during repeated plugging. The 3 ft length works as a short power cord for tight setups.
Each batch is sample-tested during production for continuity and fit. Manufactured to RoHS environmental standards. If your cord arrives defective or stops working in normal use, Cable Leader handles replacement requests directly - no manufacturer redirects.
We’ll try to get your question answered within 24 hours by a Best Buy customer or brand representative.