A:AnswerYes it will, but you must change the settings as follows
Carry out the following settings when using a speaker with an impedance of 4 – 6 Ω/ohms. 1. Press and hold the main unit’s ZONE2 SOURCE and STATUS at the same time for at least 3 seconds. “V.Format:< NTSC>” appears on the display. 2. Press DIMMER on the main unit twice. “Sp.Imp.:<8ohms>” appears on the display. 3. Press TUNER PRESET CH + or TUNER PRESET CH － on the main unit to select the impedance. 6ohms: Select when the impedance for any of the connected speakers is 6 Ω/ohms. 4ohms: Select when the impedance for any of the connected speakers is 4 Ω/ohms. 4. Press the main unit’s STATUS to complete the setting.
A:AnswerThe mic is for Audysey room calibration that is on board the receiver. Place the mic on a tripod or the paper tripod that it came with and place it on the couch at the main listening area (where you always sit). Then plug in the mic to the front of the receiver and follow the directions. You basically will move the mic to 8 different areas in the main listening area and around the area to set speaker distance, levels, crossovers and add filters to make audio corrections in your room as all rooms are different.
A:AnswerYou will definitely get your moneys worth with Denon. As long as the cd player still hooks up to red/white audio jacks or a common audio outputs it will work fine.
