A:AnswerYes, you can fill the washer before you put the clothes in, but you need to know what size load you will use. The machine senses how much water you need to make it more energy efficient. There isn't a reason to stop the cycle unless you wish to soak something or you are adding one item to the load. You can then touch the Pause button to open the lid so you can put clothes in.
A:AnswerYes. You must pause the load at the point where it is as full as you want. THEN UNPLUG FROM THE WALL! I know, crazy, right? That's the only thing I've found that works. Then when I'm done soaking, I replug and set the machine to drain and spin.
A:Answeronce you select your wash cycle just to the right of the start button is are 5 settings. On the bottom of the 5 is deep fill. Push on the word deep fill and you see the light come on to the right. That means deep fill is on and auto sensing is off. Once deep fill light is on go ahead and start.
A:AnswerI don't use pods but I'm assuming you are referring to the tray that holds the detergent, bleach and fabric softener. The tray just pulls out. I may have to look into this myself though as sometimes another family member will buy pods. I was under the impression you just dropped them in the wash. Not sure why you would have to remove the tray.
A:AnswerNo but you don't want that is why clothes come out clean best washer we have ever owned beats our lg Trom by a wide margin lg is junk I hope this helped
A:AnswerIf you want to manually add a second rinse after the conclusion of the wash cycle, select both (1) the Drain & Spin cycle and (2) the Extra Rinse option.
A:AnswerTom-They are the same. Both refer to the cavity you see looking in the washer that you put the cloths in. There is an outer tub that you cant see that holds the water which is typically high grade resin plastic.
A:AnswerYES THE FILLING TIME IS A BIT SLOW BUT THE MACHINE IS SENSING HOW MUCH WATER IS IN AND HOW MUCH MORE IS NEED. THE AGITATOR IS NOT A FAST MOVING IN THIS MACHINE BUT DOES THE THE JOB. THE WATER WILL CONTINUE TO ENTER THEMACHINE UNTIL THE MACHINE SNESES THAT THERE IS ENOUGH WATER FOR THE LOAD.
A:AnswerYes, you can rinse only. Set the washer to drain and spin with the knob, then on the right select extra rinse. It will run a rinse cycle only. I found this while researching it in the manual and online. Hope it helps.
A:AnswerYes, although the option is not listed on the panel. You must select the "drain and spin" cycle along with the "extra rinse" option (those were the instructions listed in my manual.
A:AnswerThat depends entirely on the fabric you are washing. When I have something that requires bleach, I use hot water in the cycle, and then add an extra rinse cycle.