Home Security Device and Sensor(s) Install

Before we begin

When we arrive at your home, we'll discuss the scope of work to ensure that services purchased meet your needs and expectations. If they don't, we'll recommend solutions.

Getting started

We'll install and configure applicable software or applications onto your PC or device. Then, we’ll install and configure 1 primary base station or sensor hub and connect it to your home network.

Setting up

We’ll install and configure up to 10 smart home status devices, and connect them to your home network. Devices include keypads, entry sensors, motion sensors, key FOBs, sirens, and CO sensors.

We will also install and setup one Indoor/Outdoor Camera included in the security kit.

Installation

You choose the locations, and we’ll either place or mount the smart home security devices exactly where you want them.

Giving you an update

We’ll perform software and firmware updates as needed on your new devices. We’ll also spend up to 5 minutes showing you how to configure the sensors to receive notifications and status updates.

Final steps

We’ll demonstrate how to use the new system and components, and let you know how to contact us for future support. We’ll clean up our work area, answer any questions you may have, and provide solutions as needed.

This service does not include home Wi-Fi setup, hard-wired device installation or wire runs, or DVR setup or configuration. Also not included are camera, door lock, thermostat, smoke detector, or doorbell installation.

*This service does not include monitoring services. You must enroll or register for any monitoring or surveillance services separately.

**Additional charges may be required for land travel beyond installation coverage areas. Service returns cannot be accepted after installation services are completed.