Memorial Day SaleEnds 5/25. Limited quantities. No rainchecks.Shop now

Skip to contentGo to Product Search
Main Content

Questions & Answers

$219.99
Page Showing 241-242 of 242 questions
  • QuestionJust bought this product. Plugged my Brother 5200dwt printer and I received a F02. Do I need to charge before using?

    Asked by Tri.

    • Answer I have not seen an F02 error on my unit but I did charge it before I connected anything to it. You also need to plug in the battery. The battery is in the unit but not connected. I looked up the error and the APC troubleshooting guide says: F02 = On-Battery Output Short Troubleshooting Procedure:: Turn the Back-UPS off. Disconnect all equipment from the Battery Backup outlets and the turn Back-UPS on. Re-connect equipment one item at a time. If the output is tripped again, disconnect the device that caused the error. I hope this helps.

      Answered by Guessing

  • QuestionWhat is the run time at full load?

    Asked by LIZ.

    • Answer Depends on the power draw of the system. I have one system that at load pulls over 400 watts from the wall and another that will pull less than 100 watts. it all depends on the hardware

      Answered by LunchB0xK1ller