1-1 of 1 Answer
Model (2101102) uses our Tecomec style trimmer head and does not have replacement pre-wound spools or bump knobs as it was designed to be rewound by the customer. First, removed excess line: Push the tabs on the sides of the trimmer head at the same time. 2. Pull and remove the spool cover 3. Remove any remaining line. 4. Clean dirt and debris from all parts. Replace spool if it is worn or damaged. 5. Align the spool tabs with the tab openings in the base of the spool. 6. Push the spool cover until it clicks into position. Second install the cutting line: 1. Remove the remaining cutting line on the spool. 2. Line up the slots on the spool cap with the slots (2) on the trimmer head. 3. Put the cutting line through the hole. Push the cutting line until it exits the opposite hole. 4. Pull the cutting line through until there is an equal quantity of cutting line on each side. 5. Turn the spool cap clockwise to wind the cutting line into the trimmer head. Keep approximately 5 in of cutting line above out of each side of the trimmer head. This information can be found in the owners manual.
Sorry, there was a problem. Please try again later.