A:AnswerHello, Yes, the line you are seeing above the door handle on the left side is where the Dishwasher, model KDTE204KPS, will vent. Thank you for your inquiry on our KitchenAid appliances.
A:AnswerHello! We are sorry to hear about this concern. Please reach out to Best Buy Customer Care at 1-888-237-8289 for further assistance. We hope this helps.
A:AnswerA 12" plate fits fine without impeding the upper washer arm. The clearance between the bottom rack and the washer arm is about 11.25" but the plates are at an angle when they rest on the bottom rack so 12" plates do not impede the upper washer.
A:AnswerSo far I haven't had that issue. I load my dishwasher and select the washing cycle and drying cycle--then close the door. Then the cycle begin/ starts to wash. Hum I do not any programing---just make a selection and the machine start.
A:AnswerThe Clearance between the lower and the middle rack is normally 11”. You can raise the middle rack 1” to get 12” clearance. I measured from the bottom of the lower rack to the sprayer under the middle rack. If you put the cookie sheets way on the side of the bottom rack, out of reach of the sprayer, you gain another 1/2”.
A:AnswerThank you for sharing your experience with us. We apologize for the concerns that you are experiencing with your Dishwasher, and would like the opportunity to see if we can help. Please contact us directly via Facebook bit.ly/47Ys9Pm or Instagram bit.ly/45VKWcf We look forward to speaking with you.
A:AnswerI have to admit I don't know with certainty but I think it is a fiberglass based product. I've seen foam and felt used for noise blankets and it isn't one of those yet it doesn't have the small fibers that fiberglass insulation usually has. It separates like fiberglass though. Hope that helps.
A:AnswerHello! The Depth Closed Excluding Handles(IN,inches) is 24 1/2" and the Depth Closed Including Handles(IN,inches) 26 3/4". Thank you for your inquiry on our KitchenAid appliances.
A:AnswerUnder $200. I think it would have been $177 for us. My husband is mechanically inclined & was able to do it fairly easily after we finally found the video instruction link. Written directions are not very good.
