“I seem to have misplaced the standoff screws for my artymis 323 curved monitor. Not seeing much info on the size of them, I read somewhere that you need them to mount it to a visa mount stand any help would be greatly appreciated”
Answer This Question
1-4 of 4 Answers
For proper Vesa mounting, due to the recessed mounting surface provided and the asymetric contour of the back of the monitor, I found it necessary to make thick shims (.75in approx) to level the mounting and substitute longer screws to get a correct fit of the mounting plate. You won't need the standoffs if done this way, and you'll have a level mounting surface that won't damage the back of the monitor.
Sorry, there was a problem. Please try again later.I’m sure you could find some standoffs online. It’s the typical vesa screw size, get like a 1.5 inch standoff and it should work.
Sorry, there was a problem. Please try again later.You can request for a replacement set of stand off screws using the following link below, or you can contact our customer service team to request for a set. https://service.msicomputer.com/msi_user/support/Parts.aspx or call 1 (626) 271-1004 M-F 9AM - 5PM PST
Sorry, there was a problem. Please try again later.To add to my previous answer, there are numerous sizes and designs of the mounting plates for Vesa mounting. The description of the mounting in the previous answer was for mounting of three monitors on a large stand primarily for a racing/flying simulator. However this technique could apply to most mountings, but is challenging due to the rear contour of monitor. These are unbeatable monitors so don't be discouraged from purchase because of this, You'll figure it out!
Sorry, there was a problem. Please try again later.