“Will this stereo support old 70s/80s big stereo speakers that use rca jacks/ component jack instead of the perverbial speaker wire? Also what is the return policy”
Answer This Question
1-2 of 2 Answers
Yes you can - if they are 8 ohm speakers. Many vintage speakers had either screw terminals, or the "RCA" type input jacks. These were were still 8 ohm, and you would solder the speaker wire to an RCA plug. Keep polarity correct - I always used the center pin as positive, so phasing was correct.
Sorry, there was a problem. Please try again later.Hi Gabem thank you for your inquiry. Unfortunately, you cannot use the RCA audio out ports to connect your speakers. I would recommend connecting speakers using speaker cables with the polarities + (red)/– (black) matched between the receiver and the speaker. Also, please make sure to connect speakers with a nominal impedance of 6 ohms to 16 ohms. For return policy, please contact Bestbuy for further assistance. Hope this helps! -Sam
Sorry, there was a problem. Please try again later.