1-3 of 3 Answers
Yes there is a digital switch reached via the remote. Directions to this is in the manual and an easy setup whether you are using 8 or 6 ohm. Most functions are through remote. Just make sure ohms for speakers match ohm you set. Of course be sure speakers polarity plus and negative are hooked up correctly. Is this unit over the top load? No but plenty load through good speakers. I replaced basically the same unit (10 years old) to get Bluetooth. My old one will find its way to workshop. This one is for my painting studio. Plenty of hookups for CD and turntable. It also has preamp built in. For the price it is very nice. If you want something for surround sound for tv and movies I would look for specifically designed unit. This one is really nice for music. Bluetooth pairs easily. Hope this helps. I know my granddaughters were able to connect with no issues. I had to read manual.
Sorry, there was a problem. Please try again later.Hi Megan, Thanks for your inquiry. Yes, You can set the appropriate speaker impedance for the speakers you are using by pressing the AMP MENU. The menu is displayed on the display panel. Press up/down arrow to select “SP IMP.” and then press "ok" button to select. The default setting is set to "8 ohm". Select this when you connect all speakers with a nominal impedance of 8 ohms or higher. Select “6 ohm”, when you connect all speakers with a nominal impedance of lower than 8 ohms. Note: -When connecting speakers, please make sure to connect within the impedance rating of 6-16 ohms. -If you are not sure of the impedances of the speakers, refer to the operating instructions supplied with your speakers. -Sam
Sorry, there was a problem. Please try again later.Yes the receiver has the ability to set the speaker ohms to either the standard 8 ohms or a setting I think less than that. This is done via the menu screen using the remote. Great unit...buy it!
Sorry, there was a problem. Please try again later.