“My cabinets are 12in from the back of the wall to the front edge of the cabinets. what depth are the top mounting holes to be screwed at via the template. i fear the edge boarder of my cabinets, which is about 3/4in may be in the way.”
Answer This Question
1-5 of 5 Answers
Sounds like many cabinet designs including mine, this will fit under a standard 30" wide 12" deep cabinet and with accuracy.
Sorry, there was a problem. Please try again later.You will have just enough room to work with . I had about 3/4 inch to the front bottom frame of my 12 inch depth cabinet When you mark the holes using the template/ hanging bracket and you have successfully marked the centerline on both the wall and the overhead cabinet bottom, the drilled holes will line up incredibly accurately. Install is rock solid. It is 10.5 inches on center from rear of unit to the fastening location, plus a little more for the hanging bracket and some protuberances in the back of the unit , maybe 11 1/4 total
Sorry, there was a problem. Please try again later.Haven't mounted mine yet but my cabinets might be a slight bit too shallow. One possibility to consider is a metal strip that fastens to the bottom of the cabinet recessed into the face frame and extends out far enough to engage the Microwave mounting holes if the cabinet depth is slightly too shallow.
Sorry, there was a problem. Please try again later.Hello Timmy! We would recommend reviewing the Installation Instructions for more information on proper Installation of the unit. https://www.whirlpool.com/content/dam/global/documents/201802/Installation%20Instructions%20-%20W11124888%20-%20Rev%20B.pdf .
Sorry, there was a problem. Please try again later.Timmy, the mounting bolts for me were about one-half inch from the face frame on the cabinets
Sorry, there was a problem. Please try again later.