A:AnswerYes, I just hooked it up to a 1950 Grundig Tube amp and it works fine. However if you really appreciate the full sound and warmth of listening to vinyl, I would spend the extra money and step up to the Audio-Technica AT-LP120XUSB. I have this for my main system and the sound, even with older used records is very good. With the model you are looking at, it wont play as well with older records and they wont have the warmth you are looking for.
A:AnswerNo, it only has an analog output that can be set to phono or aux levels. The Bluetooth model, AT-LP60XBT-BK, does support Bluetooth connections. It is $149.
A:AnswerNo it will not work, this is not a POWER amplifier, it is a phono preamplifier. If you already own passive type speakers, you will need to install a stereo receiver or amplifier between the turntable and the speakers. Receivers and Amplifier have a POWER amplifier inside to amplify connected sources, such as a turntable, up to a level that can adequately drive the speakers. Another option would be to use POWERED (aka active) type speakers. Powered speakers have their own power amplifier built into them so there is no need for a separate stereo receiver or amplifier. Due to the inclusion of a phono preamplifier in the turntable, the turntable may be connected to devices that either do or do not have a dedicated PHONO input for a turntable. A phono preamplifier raises the phono level signal from a turntable (which is very weak) to a stronger line level signal (such as that which you get from a CD Player) so it can drive the preamplifier section of a receiver, amplifier or powered speaker, then the preamplifier drives the power amplifier. Its all about gain staging so that, in the end, you have a good signal to noise ratio. A phono preamplifier also applies the RIAA equalization curve which is required for the playback of records.
A:AnswerThe at-lp60 is a budget turntable with non-replaceable cartridge. It can only accept two replacement styluses that I’m aware of, a conical stylus atn3600l and an elliptical stylus cfn3600le.
A:AnswerYou can either use a stereo amplifier or receiver with passive speakers attached to the amplifier or receiver, or you can attach the turntable directly to a set of powered (aka active) type speakers. Powered speakers have the amplifier built into them so a separate amplifier or recover between the turntable and the speakers is not required.
This applies to all of our 60 Series turntables and any of our other models featuring a built-in phono preamplifier.
A:AnswerNo, you don't have a problem. You won't need a grounding wire with this unit anyway since magnetic cartridges generally don't need a grounding wire. Just leave your grounding wire where it is.
A:AnswerThe Bose speaker has no preamp so you’re only hearing the low volume from the turntable. You need either active speakers or a receiver connected with passive speakers
A:AnswerYou can connect the turntable to the AUX In jacks on the Samsung Home Entertainment System. Make certain that you turn the phono preamplifier inside the turntable ON by placing the preamp selector switch on the back of the turntable in the LINE position.
