“will this work with otter box cases for iphone 7 plus ???”
Answer This Question
1-10 of 10 Answers
Should work on about any device case. The magnet that holds the device to the mount (2 different magnets included) can be attached several ways. Either to the phone or the case. SO the Otter Box case shouldn't create a problem - peel the cover off the magnet and press the glue side to the back of the case. Or you can probably place the magnet between the phone and case. I have a dinky little case for my iPod and I just put the smaller magnet between the iPod and the case. Works like a charm - every now and then the iPod falls off the mount but its because of constant handling and not the magnet. If I used the full side magnet it would probably never slide off.
Sorry, there was a problem. Please try again later.Yes all you have to do is attach the 3m adhesive plate to your otter box and boom all done, and will hold strong
Sorry, there was a problem. Please try again later.IF YOU HAVE A CASE THAT USES A MAGNETIC BACK IT WORKS
Sorry, there was a problem. Please try again later.I think it should call the company
Sorry, there was a problem. Please try again later.It should work
Sorry, there was a problem. Please try again later.The magnet is very powerful It should work
Sorry, there was a problem. Please try again later.Yes it will holds my 6Splus great.
Sorry, there was a problem. Please try again later.I have an otter box; I place the metal plate they provide between the hard plastic and the rubber exterior part and works like a charm. I did at first notice that it was slightly pulling the rubber, which is to be expected and didn't matter once I considered the use I'm getting out of it X_x
Sorry, there was a problem. Please try again later.Yes, because it has two different sizes of magnets.
Sorry, there was a problem. Please try again later.This product does not work with phones that have cases on them.
Sorry, there was a problem. Please try again later.