1-9 of 9 Answers
I did too. You can adjust both in the refrigerator, but if the freezer still isn't cold enough, you can adjust it higher in the freezer
Sorry, there was a problem. Please try again later.I've had same experience. I had to max out the temperature setting to get ice cream to desired texture.
Sorry, there was a problem. Please try again later.Had the same problem. Turns out frig was defective had to return it. Got the same one because of the good reviews and I went in the store and compared frigs. This was on in the store and worked fine was really cold. Anyway got a new one all is well
Sorry, there was a problem. Please try again later.For hard Ice cream, you want the temp to be -10 or more(-20) for super hard ice cream. I use to drive truck and we set our trailer temp at -20 when hauling ice cream. Kept it good and hard.
Sorry, there was a problem. Please try again later.Set your freezer temp control to just above the * marks in the middle of the guide. This should be good for ice cream.
Sorry, there was a problem. Please try again later.Yes, same experience. Ice cream soft & freezer unit runs too warm. I've played with adjusting both compartments & finally got it to zero in the freezer & 40 in the frig. These seem to be the recommended temps, but it's taken quite some time to keep adjusting in order to get these temps.
Sorry, there was a problem. Please try again later.Hi Larry, Thank you for your submission. We certainly understand your concern about your freezer not being cold enough and recommend you to contact Frigidaire consumer care at your convenience for troubleshooting assistance. Thank you for allowing us to assist you with your inquiry. Respectfully
Sorry, there was a problem. Please try again later.get a service man..
Sorry, there was a problem. Please try again later.For extreme temp outside, I think the directions tell you to use the maximum setting for the freezer. We are outside St. Louis, O'Fallon, and have had 20 degree temps in the garage this winter. All ok.
Sorry, there was a problem. Please try again later.
