A:AnswerLooking at the second "3" in the s\n and according to the NOMENCLATURE about it leads me to believe that it may have to do something with the color scheme. Otherwise the new microwave is going to have updated hardware. Hope this helps. As for your photo, that wasn't shared. But I was able to mount on my own.
A:AnswerNot exactly sure , u need to measure both old and new microwave u are purchasing to assure fit and your space depending on your kitchen thats what i did.
A:AnswerGE no longer makes at 36" over the range microwave. The largest they make is a 30" which is PSA9120SPSS.
You can solve the size difference by ordering filler panels you would need to order directly from GE - JX52BL, comes with a pair of 3" panels.
https://www.bestbuy.com/site/ge-profile-advantium-30-built-in-single-electric-convection-over-the-range-oven-with-microwave-stainless-steel/6467030.p?skuId=6467030
A:AnswerI’m a bit of a handy man, so when I replaced my old over the stove microwave, with a new one that had a fan built in, I just hooked it up to the existing venting. …it’s little bit awkward, but I did all the necessary retrofit. …so depending on your abilities you may call someone to install it. Recently I had one installed through Best Buy because it was for a rental I own.
A:AnswerAbsolutely Not! Maytag is much better quality. This GE will be fine for about a year--until the warranty runs out. Then it will start blowing fuses in the door due to a design flaw. (Read other reviews on the blown fuses.) We finally threw it out--and went with a Whirlpool. (It was such a horrible experience that we vowed to never buy another GE appliance again.)
A:AnswerNot sure but I had a previous model and I had to drill new holes for the hanging bolts and for the power cord. Takes two people to lift into place.
A:Answerif you have a geek squad account it is well worth it as they will service all of your appliances, without a service charge if you have geek squad total.
A:AnswerThey are the same model, but with slight changes only in the mounting bar on the back wall and a missing hole for middle, front supporting screw.