“Just got this pc and don’t see the screws as shown on the manual to get inside and remove the protective packing foam, is there a location for the screws?”
Answer This Question
1-4 of 4 Answers
Mine did not have screws. On the top left, there is a small indent where the side pops off. Even easier than screws.
Sorry, there was a problem. Please try again later.It only took me about an hour to get in, with a tip in this thread that sort of helps you get the top-plate off (pull up at 3 inch indent at center rear). To get side panels off; there are zero screws & zero instructions. At upper-most back corners (both sides) there are about 3 inch what can only be described as 'handles,' which you "gently" pull straight out, away from the cabinet, I say gently bc pulling the left side out you inevitably (due to this unfortunate design) tweak and bend the glass panel but eventually it pops off. Before you attempt this, have a witness record with phone and cross your fingers the glass doesn't shatter on you. Good luck!!
Sorry, there was a problem. Please try again later.there is a little lip at the top near where the triangle is that you pull up away from the computer, the glass will bend a little then pop off, just helped a friend about this issue.
Sorry, there was a problem. Please try again later.The thumb screw should be located on the back of the case close to the top side.
Sorry, there was a problem. Please try again later.
