“What size hole needs to be drilled to fit the ends of these cables”

1-3 of 3 Answers

• 5/8th inch paddle bit

  Answered by BSav 6 months ago

  • 

  Helpful (0)Unhelpful (0)

  Report

  Sorry, there was a problem. Please try again later.

• 7/16" or 1/2". 3/8" is a bit snug.

  Answered by NITRO27 7 months ago

  • 

  Helpful (0)Unhelpful (0)

  Report

  Sorry, there was a problem. Please try again later.

• Hi Bob, Thanks for your question! The Insignia™ 150' Cat-6 Ethernet Cable uses standard RJ-45 connectors, which are approximately 0.57 inches (14.5 mm) wide and 0.31 inches (8 mm) tall. To ensure a comfortable fit when routing the cable through a hole, we recommend drilling a hole that is at least 3/4 inch (about 19 mm) in diameter. This allows enough clearance for the connector and any strain relief boot it may have. -Ed | Insignia Support | https://www.bestbuy.com/site/brands/best-buy-brands/pcmcat1596746025285.c?id=pcmcat1596746025285

  Answered by InsigniaCustomerSupport 7 months ago

  Helpful (0)Unhelpful (0)

  Report

  Sorry, there was a problem. Please try again later.