1-4 of 4 Answers
I know this is really old but I had the same issue and thought someone else might need this answer. I read it's all about the small diameter of the screw holes. It seems like the screwdriver is doing the job but at a certain point it's actually just spinning. Get yourself a #0 size screwdriver and you'll be able to properly tighten the screws.
Sorry, there was a problem. Please try again later.Keep tightening the screws until it doesn't wobble despite it feeling like you're going to strip the screws. The plastic holes in the display may need to be threaded so the screws will take. You can also try fastening just the screws first to prep the holes, remove the screws, and then reattach the leg stands per the instructions.
Sorry, there was a problem. Please try again later.Tighten the screws underneath both legs. Two screws in each leg.
Sorry, there was a problem. Please try again later.MAYBE WHEN YOU INSTALLED THEM YOU DIDN'T TIGHEN THE SCREWS ALL THE WAY , ON MY SET I JUST PUSHED THE LEGS INTO PLACE THEN TIGHTLY SCREWED THE SCREWS WITH A LONG STEM PHILIP SCREWDRIVER I GUESS I GOT LUCKY INSTALLING THEM , PRETTY SIMPLE.
Sorry, there was a problem. Please try again later.
