I’ve had this TV for two months and now the only buttons that work on the remote are the power, volume and channel buttons. If I turn the tv off and then back on I can access the inputs but can’t switch between inputs once it’s on. Any solutions? null

Question

InsigniaCustomerSupport · Accepted Answer

Try this, to Factory Reset the Remote, press and hold at the same time the DPAD-left, Back (↩) and Menu (≡) buttons for at least 12 seconds. To pair the remote again, press the Home button for up to a minute.

Answered by InsigniaCustomerSupport 4 years ago

Quality · Answer

Unplug tv, > take batteries out > put every button for 5 sec each > press all buttons like the piano sweep across. 
Turn tv back on and it should be working properly

Quality · Answer

The problem probably is the remote, keys get stuck it’s a problem a lot of newer tv have. 
First unplug your tv, then take out your controller batteries. After that that press every button down for atleast 3 seconds after once again for 5 seconds. 
Finally run your finger through all the buttons back and forth a couple of times. 
Your remote should be working properly after that.

Look on YouTube if instructions not clear enough.

“I’ve had this TV for two months and now the only buttons that work on the remote are the power, volume and channel buttons. If I turn the tv off and then back on I can access the inputs but can’t switch between inputs once it’s on. Any solutions?”

1-3 of 3 Answers