“Can I set up deliver/install Klipsch 12" 400 watt subwoofer over phone or via computer without going to the store. I recently had new Denon avr1600 receiver installed was happy with that install”
Answer This Question
1-3 of 3 Answers
Do you know how to run the sound test, with the special mic that comes with, well jut connect you're rca jacks in there proper out puts on you're Denon, then plug the amps power cable in to the wall and start the sound test. Once it gets started the woofer is in the beginning, it will tell you how to adjust you woofer, my Denon is connected to my flat screen with an HDMI cable so I can see all this on my screen, big help. Kilipsch has a real great Customer support if you need them, Hey I call them and Denon when I need them, and That is what they want you to do.
Sorry, there was a problem. Please try again later.This subwoofer can be purchased online and installation of this sub is easy! You will need a single male-male RCA subwoofer cable to connect this sub to your Denon receiver. Connect one end to your receiver's RCA Subwoofer output and then connect the other end of the cable to the R-120SW's RCA Line Input labeled "LFE." For guidance on what adjustments to make to the Low-Pass and Gain dials of the subwoofer, please reach out to Klipsch Support to speak directly with a product support representative. For Quickest contact, we recommend opening a "chat" - https://bit.ly/klipschsupport
Sorry, there was a problem. Please try again later.If you're asking what I think, then yes very simple to install. I have a Demon 5.2AVR and I don't (not yet anyway) use two subs. So you'll have to plug the wire into the LFE on the sub and on the number 1 output on the AVR, and also the gain on the sub not the volume has to be turned all the way to the right so the AVR and sub play they way it should.
Sorry, there was a problem. Please try again later.