A:AnswerClosets with doors must have both an upper and lower vent to prevent heat and moisture buildup in the closet. One upper vent opening with a minimum opening of 48 sq. in. (310 cm2) must be installed no lower than 6 feet above the floor. One lower vent opening with a minimum opening of 24 sq. in. (155 cm2) must be installed no more than one foot above the floor. The width of the unit is 27”. For the door to open 90˚ you need 55”D. To ensure sufficient clearance for water inlet hoses, drain hose and airflow, allow minimum clearances of at least 1'' (2.5 cm) at the sides and 4'' (10 cm) behind the appliance. ^Daphane
A:AnswerThe unit is 74-3/8". To ensure sufficient clearance for water inlet hoses, drain hose and airflow, allow minimum clearances of at least 1'' (2.5 cm) at the sides and 4'' (10 cm) behind the appliance. Be sure to allow for wall, door, or floor moldings that may increase the required clearances ^Daphane
A:AnswerMost all front load units have issues with odor. We recommend cleaning the door gasket and seal regularly. The washer has a Tub Clean cycle. Tub clean is a special cycle designed to clean the inside of the washer. ^Daphane
A:AnswerYou will need a 110v connection for the washer part and a 220v connection for the dryer part. Other than that there are the normal hot/cold water in and drain for water out and the dryer air out that are needed.
A:AnswerThe WashTower is available vented only, but I used a filter with a water reservoir on a similar dryer for many years successfully. It does add humidity to the indoors, but it worked fine for me.
A:AnswerThe part number for the side venting kit is 3911EZ9131X. It can be ordered from Encompass at https://lgparts.com/item/6690199/LG/383EEL9001B/. ^Daphane