“Outside of fill hoses, what else is needed to properly install this unit? Thank you”
Answer This Question
$1,899.99
Save $1,000
The comparable value is $2,899.99
Deal ends in 9:53:48
1-2 of 2 Answers
You will need a 110v connection for the washer part and a 220v connection for the dryer part. Other than that there are the normal hot/cold water in and drain for water out and the dryer air out that are needed.
Sorry, there was a problem. Please try again later.The required accessories for installation beyond the hot/cold hoes for the washer are a cold water hose for the dryer for steam and the power cord for the dryer. The dryer has its own terminal block that must be connected to a separate 240 VAC, 60-hertz, single-phase circuit, fused at 30 amperes (the circuit must be fused on both sides of the line). Electrical service for the dryer should be of the maximum rate voltage listed on the nameplate. Do not connect the dryer to 110, 115, or 120 volt circuit. ^Daphane
Sorry, there was a problem. Please try again later.