“This dryer isn't ventless but when I chose delivery and installation, it only adds "washing machine hose" as a part and no vent or cord. Is that all that's needed to install the dryer?,”
Answer This Question
1-2 of 2 Answers
I had the same description, but received a cord and vent kit. The description is incorrect.
Sorry, there was a problem. Please try again later.The parts need to complete installation for this dryer include the hoses for the steam feature, vent and a power cord. It is recommended to use a heavy metal vent. Use only 4-inch (10.2 cm) rigid, semi-rigid or flexible metal ductwork inside the dryer cabinet and for venting outside. The total length of flexible metal duct must not exceed 8 ft. (2.4 m). The dryer is configured to vent to the rear. It can also vent to the bottom or side (right-side venting is not available on gas models). An adapter kit, part number 383EEL9001B, may be purchased from your LG retailer. The dryer has its own terminal block that must be connected to a separate 240V, 60-hertz, single-phase circuit, fused at 30 amperes (the circuit must be fused on both sides of the line). Electrical service for the dryer should be of the maximum rate voltage listed on the nameplate. Do not connect the dryer to 110, 115, or 120 volt circuit. ^Daphane
Sorry, there was a problem. Please try again later.