“What are the full instructions for this product? Please share the PDF/URL of instructions/specifications. I don't see them on your site and your shipment process erroneously puts labels all over the item, including the instructions. Thank you.”
Answer This Question
1-3 of 3 Answers
We measured the length desired then cut the cover with a jig saw. We then peeled the adhesive cover off the cover and attached it to the wall (make sure that is exactly where you want it to be because there is no moving around once it is attached). We then placed the cables inside and closed it up. Same thing happened with regards to the stickers when I purchased mine!
Sorry, there was a problem. Please try again later.Instructions: 1. Wall surface must be clean.Do not use on textured surfaces. 2. Cut Channel to desired length. 3. Insert cord and snap shut. 4. Peel Liner from tape. 5. Press firmly against wall. 6.Use couplings and elbows as needed. Ideal for: HDMI cables, Component cables, Data cables, Coaxial cables, Speaker cables, Computer cables, Printer cables and Power cords Warning: -Not to be used to extend hard-wired (permanent) electrical wiring -Two power cord maximum -Do not loop cord Features: -Hinged, one-piece design -Easy open and close -Paintable: Use Latex paint -Easy peel and press installation Contains: 1. 4pcs 30-in channel— A 2. 3 couplings— B 3. 1 Flat elbow— C 4. 1 inside elbow— D Refer for the photos below for more info.
Sorry, there was a problem. Please try again later.please reach out at 1-800-621-0049 or email at [email protected] and we would be happy to help.
Sorry, there was a problem. Please try again later.
