“how do i get it to connect with my HP desktop? will not connect to my HP desktop”
Answer This Question
1-8 of 8 Answers
this is plug n play, should be recognized under my computer. if its not, i suspect u have a bad drive. 2 obvious choices, plug into someone else computer and verify or return. very rare, but i have seen a bad cable before. you could try plugging it in and rebooting and see if it gets detected under startup. fyi, 3.0 is backwards compatible in most cp's. will read 2.0 unless its a 3.0 port - the speeds are DRASTICALLY different. 3.0 ports are typically blue.
Sorry, there was a problem. Please try again later.WHAT OPERATING SYSTEM IS IT IF IT IS BEFORE WINDOWS 98SE YOU'LL NEED TO INSTALL DRIVERS
Sorry, there was a problem. Please try again later.Plug it in
Sorry, there was a problem. Please try again later.It should connect automatically with "Plug & Play" feature on PCs. You may need to go into computer management functions to load or install a USB port.
Sorry, there was a problem. Please try again later.The drive comes with a USB wire. I'm sure your hp desktop has a USB port...unless it's ancient. Simply plug it in. USB plugs only go in one way...If it wont go in...turn it over and try.
Sorry, there was a problem. Please try again later.Just plug it in and it works!
Sorry, there was a problem. Please try again later.it should just pop up. if it does not, then you should take it back. it should work with any usb connection.
Sorry, there was a problem. Please try again later.Check to see if your computer needs to be updated to accept the 3.0 drive. Also check HP and Seagate to see if they have the drivers. Your system needs to be able to read USB 3.0
Sorry, there was a problem. Please try again later.