“I have a harbinger m200bt PA system that doesn’t have sub input or output can I still connect this to my system”

1-3 of 3 Answers

• Carefull with the M200 BT amp. I destroyed my M 200 BT just by not being cautious, having 1 main switch turning everything off at the same time. I was careful to turn instruments on and then the M200 power mixer on. And when turning off I would turn the main switch to the surge protector off instead of turning the M 200 off first then the instruments hooked up to it. Don't do as I did, as mentioned up above.

  Answered by Anonymous 2 years ago

  Helpful (1)Unhelpful (0)

  Report

  Sorry, there was a problem. Please try again later.

• It does have the spring loaded speaker in/out jacks, so that might work.

  Answered by Jeffafa 5 years ago

  • Verified Purchase
  • 

  Helpful (0)Unhelpful (0)

  Report

  Sorry, there was a problem. Please try again later.

• Hi Jae, Thank you so much for your inquiry! If your Harbinger M200-BT support one or both of the following connections, yes, you can connect it to our SA-CS9 to your system: - MONO OUT jack - MIX OUT jack - SUBWOOFER output jack(s) - SUPER WOOFER output jack(s) • You can also connect your amplifier or AV receiver if it does not have the above-mentioned output jacks to the SPEAKER IN terminals of the subwoofer. I hope this helps! Sincerely, Romeo

  Answered by SonyListens 5 years ago

  Helpful (0)Unhelpful (0)

  Report

  Sorry, there was a problem. Please try again later.