“Just purchased the UBP-X800, came home and hooked it up to my brand new Yamaha Aventage A860 (which plays Atmos sound), programed everything through my Harmony Elite controller and put in "Hacksaw Ridge" UHD/Atmos ...no Atmos sound. i to Changed Bitstream”
Answer This Question
1-4 of 4 Answers
try running 2 hdmi cables
Sorry, there was a problem. Please try again later.Dolby ATMOS can read a bitstream. The UBP-X800 needs to have its audio output setting set to bitstream. Your Yamaha Aventage A860 should have read the bitstream and used its ATMOS codec (processor) to provide you with ATMOS surround sound. I assume this was the case.
Sorry, there was a problem. Please try again later.That shouldn't matter. In PCM mode it should still do the ATMOS sound. I too have the Elite remote (in fact I had a problem and Harmony techs are wonderful. In your post you never answered whether switching to Bitstream helped your issue of not being able to hear ATMOS. Did it solve the problem? Not really sure what the advantage is to using Bitstream vs PCM other than the commentary on some movies if you leave it in PCM mode. What is the advantage to using Bitstream?
Sorry, there was a problem. Please try again later.Hi Chris, To access the Dolby Atmos feature of the player. Use the supplied remote and set [BD Audio MIX Setting] in [Audio Settings] to [Off]. If you're still getting the same result, please contact support for your receiver for the correct settings. Thanks, >Joffrey
Sorry, there was a problem. Please try again later.
