Customer Ratings & Reviews

I have track molding from my wall mounted shelf up to the ceiling and towards and down my projector screen to my home theater system. Looks just fine. But I replaced my shelf and had to remove a little bit of the track molding and it pulled up the paint with it because the adhesive is incredibly strong.

Great product - excellently built. Has a VERY sticky tape on the back. The tape is SO good, that you will pull the paint right off of your wall if you decide to remove it :)

Wasn't as good has I had hope for. Only hold 2 cord at best. Alittle pricy but I rather get something eles for the cost or pay alitte bit more for a better product..

I was skeptical about the sticky backing of first period but I have had it for about a month and that is holding tight and works great and looks great. I have not tried to open it up since it's been installed on the wall too add new cords.

I have used this to clean up surface mounted wires on my office walls... It holds great with the included adhesive, and the size is great for running a couple of the wires together...

Nobody likes looking at a rat's nest of loose cables, so this kit is good for trying to tidy up the cables in a small business or home office. As far as painting it to match the wall color, you would probably need to take a sample of the wall paint if you wanted the truly seamless look.

We had a small tv mounted on our wall. I didnt want to see any cords. This worked out qell. We were able to hide the access cords. This was a good choice.

if you question "is it going to hold everything I need it to?" error on the side of caution and size up. Also, make sure that you have thoroughly cleaned before mounting

Purchased to cover wires from my ceiling mounted projector. Adhesive backing worked better than expected on textured ceiling. Struggled at getting power cord and HDMI cord in-as it was a very tight fit to get it enclosed. Other than that looks great.

This is a great set for the price. Lots of different pieces allow you to choose which is the best way to run your cables. They are a little stiff to open, especially after they are mounted.

Curved pieces not installed so black cable still obvious. ? Installation error?

Not bad. Only fits 2 HDMI cables and if the cable has a fat piece towards the end like some you can just forget fitting it in there properly.

Works great. Adhered to the wall very well. A little difficult to trim to the size you need but that also shows it’s made well and not flimsy.

If there is one thing I hate is when speaker wires are exposed, so I recently bought a set of new speakers, and wanted to make sure the wires were not visible.

Had to return the item because we found a better way, the Geek Squad did the job.

This is the 2nd time I have bought this product to hide cables. It makes a nice neat look once it is painted. Very Sticky so make sure placement is correct before you push to the wall. Comes with many adapters for different angle's and corners.

This kit had enough to do two rooms. One room was not a very long run. The covers took the latex paint I originally used for the room well. We'll thought out kit, and had everything to do the job.

The combination of the thin cable guide and flat-cable extension cord worked perfectly to baby-proof the wiring going from the wall plug to the back of the TV.

After wall mounted speaker wire came loose and fell, had to fish at the bottom of the wall. Only solution cost effective, run the wire outside of the wall.. No access was available through the basement (it's finished)

I got 3 cables to fit, one being power. Cut to length, laid cables in and snapped shut. Peel off backing and stuck to wall. Easy and effective.