I want to know more about how to install it. is this like using an adhesive tape? thank you. I don't want to put a hole on my door so I'm kinda hoping this is an actual wire free doorbell. Thank you null

Question

Rafael · Accepted Answer

While you can use an adhesive strip on the door, I don't think it would be recommended as it would be easily to be removed/stolen. However, you can do on the side of the door on the wall and mount it with anchors/screws (included). That being said, if installed properly ARLO will replace any stolen equipment.

Answered by Rafael 5 years ago

KTSCC · Answer

I installed mine today. You can either wire it where your old doorbell was or install it completely wire free. It has a bracket that you screw in to the wall and the doorbell snaps into the bracket. A special tool, which is included, is required to remove the doorbell from the bracket to charge the battery.

Answered by KTSCC 5 years ago

Verified Purchase

ArloTeam · Answer

To install the Arlo Video Doorbell camera, you would need to drill a hole to securely mount it. ^RM

Steve62305 · Answer

It is a wire-free doorbell. I used Gorilla brand double-sided mounting tape to install mine. Of course, if you install it during cold weather you may want to use a heat gun to warm the the home's exterior surface before you apply the mounting tape.

Answered by Steve62305 5 years ago

Browny · Answer

No adhesive supplied. The Arlo doorbell has two holes one at the top and bottom so you can securely mount it to the door or wall. 
I'm in a Co-op and I'm not allowed to drill on the the exterior, I'm planning on gluing it down.

skywing1 · Answer

Try Doorbell Boa. It mounts to your door without screws. It uses constricting brackets and works with non hard wired ring and similar remote systems.

Answer

Ppl are saying it can get stolen if you don’t drill it or whatever but even if u do that it can still get stolen because it still detaches so u can change the battery. I can’t drill holes outside my apartment so I have to use adhesive or something else to hold it up regardless

Answered by Anonymous 3 years ago

Dickey · Answer

You could use "No Nails."

If you don't want it getting stolen you should really drill your door.

“I want to know more about how to install it. is this like using an adhesive tape? thank you. I don't want to put a hole on my door so I'm kinda hoping this is an actual wire free doorbell. Thank you”

1-8 of 8 Answers