“Purchased first 252 epson replacement cartridge for my WF-7710 printer (but not the 'i' version that shipped with the printer). Immediately after replacing, print quality is very poor and door over cartridges is hard to reopen. Ideas?”
Answer This Question
1-3 of 3 Answers
go to help menu on the display screen. scroll down to "maintenance". within the menu scroll down to "replace cartridge". click that. the cartridge carrier will then move way left then move back to the right, stopping just the right place to allow you to pull on the plastic cover tab and lifi it up. next, squeeze the top tab on the cartridge you want to replace - while doing that, pull from the top of the cartridge and remove it. Find the new cartridge an be SURE to REMOVE the yellow sticker attached to th top side of the cartridge. Next, slide that new cartridge into the slot where the old one was. press it down until the tab at the top clicks. next, roll the black plastic using its tab back over all the cartridges press down until it clicks. the help menu on the printer screen takes you thru step by step. it appears that you might not have followed all the steps in installing the new cartridge. xt
Sorry, there was a problem. Please try again later.You have to tell the printer to "replace cartridge now" and then the carrier with the cartridges will move over to the open space. If you do not have your manual, you can download from Epson or other sites. If the print quality is poor you may need to clean the heads under maintenance. Again, a manual is handy for troubleshooting.
Sorry, there was a problem. Please try again later.Try removing and re inserting. Sounds like wasn’t loaded right
Sorry, there was a problem. Please try again later.
