plugged in the optical cable into the box and tv.Used the red white cord that came with and plugged it into the box and the receiver. However, there r many places it could go, i tried them all and still no sound. adjusted the tv to reflect surround sound null

Question

Eddie · Accepted Answer

I had the same problem. Went on Google and found the answer. There is a SOUND setting on your TV. I was instructed to switch it away from the factory setting to the alternate choice and it work fine immediately. Unfortunately, I don't remember the two SOUND setting choices - but you may be able to find the same site that I found - or just try to look at the SOUND setting options on your TV. and switch them.

Answered by Eddie 7 years ago

Verified Purchase

DamienS · Answer

The analog/RCA side goes into the "audio in (2 channel)" on the receiver for the audio mode you'll select when watching TV. Make sure your TV's audio setting has the digital out put turned on. Most are off by default.

Answered by DamienS 4 years ago

berwicklaw · Answer

" Did you remove the protective rubber caps on the end of the optical cables ? "

Dimitri · Answer

The source(tv) has to be plugged in the “ out” / “ output “ sockets 
The receiver -look for a “ in”/ “ input” sockets. Audio and Video, respectively. Hope this helps.

“plugged in the optical cable into the box and tv.Used the red white cord that came with and plugged it into the box and the receiver. However, there r many places it could go, i tried them all and still no sound. adjusted the tv to reflect surround sound”

1-4 of 4 Answers