“I just bought mine used without a manual. I programmed it... I think, but when i put it up to the charger to charge, it beeps. What is it trying to tell me?”

1-3 of 3 Answers

• There is a side switch on the side of the robot vacuum (two inches to the right of the charging prongs located at the back of the robot). This switch needs to be in the “ON” position while charging and in use. If in the “OFF” position while on the docking station or directly plugged into the AC adaptor, it will not charge properly.

  Answered by Help Desk 7 years ago

  Helpful (13)Unhelpful (3)

  Report

  Sorry, there was a problem. Please try again later.

• while it needs charging it will sound a beep, as soon as the battery is full the beep is going to stop

  Answered by Malena 7 years ago

  • Verified Purchase
  • 

  Helpful (0)Unhelpful (0)

  Report

  Sorry, there was a problem. Please try again later.

• Did you turn the power button on on the vacuum? Mine was doing that until I turned the power button on.

  Answered by Paula 7 years ago

  Helpful (2)Unhelpful (3)

  Report

  Sorry, there was a problem. Please try again later.