Also on the 656 I have presence or high speakers connected however when doing the calibration the system showed them a rear surround speakers, how can I can change this?

Thank you null

Question

Also on the 656 I have presence or high speakers connected however when doing the calibration the system showed them a rear surround speakers, how can I can change this?

Thank you null

DanceMaster · Accepted Answer

I had a similar problem. First, use the remote that comes with the system, I initially used my harmony and I had problems. Make sure that you have the system wired correctly (I had my negative and positive on one speaker wired in reverse and it cause a problem with the calibration, also make sure that all speaker have the same ohm impedance. Second if you do not have zone 2 wired, put it on not act, I didn't think that this was important and I did nothing. If you do not have a bi-amp put speakers on normal and set accordantly. Next make sure your speaker configuration is correct. This where I made the mistake of not doing it accurately. Look on the screen and make sure that the speakers look the same on the screen as they do in your room. I do not know if this will help your problem, but it did for me.

Dance Master

Pauliff · Answer

You need to set the type of speakers in there setup menu before running the calibration. Then run the calibration

52john · Answer

Unless you have a 7.2 setup with seven speakers and sub, then you won't get Atmos setup no matter where your 5.2 speakers are located. 
I don't know what you have setup due to lack of info, and I'm not an expert.

“Also on the 656 I have presence or high speakers connected however when doing the calibration the system showed them a rear surround speakers, how can I can change this? Thank you”

1-3 of 3 Answers