“How "bendable" are these? I know I can't cut them without a problem but could they curve 90 degrees to go under some kitchen cabinets with a corner?”
Answer This Question
1-10 of 10 Answers
They can be bent 90 degrees, as long as the bend is in between the led's in the lightstrip.
Sorry, there was a problem. Please try again later.They can bend pretty tight. If you're concerned about it, you could always build a curved "block" to stick in the corner of the cabinet to give a decent radius for the lights. This is what I did for my install - except it was an outside curve not an inside curve. I wasn't real comfortable bending them at a hard 90*.
Sorry, there was a problem. Please try again later.you CAN in fact cut them. Each strip (NOT Extention) is marked where it can be cut.. , They are about as flexible as a thin leather belt..
Sorry, there was a problem. Please try again later.Absolutely
Sorry, there was a problem. Please try again later.They arent that bendable if you have them on the bottom of the cabinets. I have the lights laid across the top of my cabinets that do a curved 90 degree and even at the curved part it's hard to get them to bend without just lining it up against the wall.
Sorry, there was a problem. Please try again later.They are pretty flexible. I put it behind my daughters bed for a night light and it bent with ease. I am planning on using them under my cabinet. A 90 degree angle would be easy for the strip.
Sorry, there was a problem. Please try again later.u can curve them to a soft 90 but if u try to bend it sharp ul sendup with problems
Sorry, there was a problem. Please try again later.they are not bendable for 90 degrees. more like a "loop". The loop will be ornery. try to imagine using a belt. it is exactly like a belt you would wear.
Sorry, there was a problem. Please try again later.It can bend pretty close to 90 degrees, if not exactly. We've used alternate adhering methods (fun tack) to try to give ourselves more options, so you might have better luck with a tight corner if you actually use the adhesive on the strip.
Sorry, there was a problem. Please try again later.You can however be very careful as i did that and it worked. But when i moved my light to a new location a bunch of the leds stopped working where the bend happened.
Sorry, there was a problem. Please try again later.