“I get a "no signal found" message after hooking up this player. If my current HDMI cable is a pre-4K cable, will I get any signal at all? It's connected to a pre-4K surround sound Denon receiver.”
Answer This Question
1-2 of 2 Answers
Had the same issue at first until the player had been on for about 10min. Then I kept looking for the source then it started then I was able to complete set up and haven’t had a problem since however I did use a 4K hdmi
Sorry, there was a problem. Please try again later.Hello UncleBoris, you just need to select the right input on the receiver. For reference, please check the link below: https://www.sony.com/electronics/support/res/manuals/4579/45796691M.pdf, see page 17 onwards. Regards, _Bob
Sorry, there was a problem. Please try again later.
