“Is this required for installation of a Pyle backup camera? It was recommended as part of the package.”
Answer This Question
1-10 of 12 Answers
My understanding of tilt switch is for only one reason, to keep someone from being hurt if the engine is started by a remote. The vehicle could be out of sight when the remote is used. You can run the engine with the hood up, just can't use remote to start.
Sorry, there was a problem. Please try again later.I don't know if it is required for that system but it was recommended as part of the one I bought.
Sorry, there was a problem. Please try again later.This is a Tilt Switch, which senses a significant change in the angle of whatever it is attached to, such as a car hood or trunk lid. Typically, backup cameras are attached to the Backup Lights from inside the trunk, to activate the camera. Because the car doesn't "tilt" when backing up, this switch would serve no purpose.
Sorry, there was a problem. Please try again later.This was a required part for the installation of the remote starter for a Toyota Venza.
Sorry, there was a problem. Please try again later.No it not required
Sorry, there was a problem. Please try again later.Good
Sorry, there was a problem. Please try again later.Works grest
Sorry, there was a problem. Please try again later.No this was for a car starter.
Sorry, there was a problem. Please try again later.Definitely not.
Sorry, there was a problem. Please try again later.I am not sure, I know I needed it for the remote start installation.
Sorry, there was a problem. Please try again later.