“I have only 35 inches for the total depth of this unit-will this work for me-what is the total depth once installed?”
Answer This Question
1-2 of 2 Answers
My space from wall to units end is just shy of 36 mins. You,'ll be very close at 35.It may work.
Sorry, there was a problem. Please try again later.Hi bear - The unit is 30 7/8" deep so you should be fine with installation in a 35" space. See Installation Guide at the following link (Page 3 REQUIREMENTS FOR ALCOVE OR CLOSET INSTALLATION: https://products.geappliances.com/MarketingObjectRetrieval/Dispatcher?RequestType=PDF&Name=31-16781-3.pdf - Note: The dryer is deeper in the rear than the washer. The overhang is 4" past the back panel of the washer, which means it sticks out past the vent, electrical, and plumbing connections. The dryer can sit up against a wall without adding any extra depth to the unit. This provides space for the connections in the rear. Because of this overhang, the unit does not need knockouts to vent to the left or right side. The vent elbow can be turned left, right, or down as needed. For side venting, 3 additional inches of room depth are needed versus the unit depth shown in the manual. The vent needs to go down first and then to the left or to the right. Thanks for choosing GE! Sue
Sorry, there was a problem. Please try again later.
