1-10 of 12 Answers
Yes. All my components are in the basement under my family room and all commands are taken by the hub via RF, not IR. The hub then emits IR via little IR blasters that are wired to the hub. You WILL need to be able to route one of the blasters to your TV so it can emit IR to control it.
Sorry, there was a problem. Please try again later.This remote includes a Logitech Hub. The Hub actually does all of the controlling. It receives instructions from the remote and then transmits the appropriate signal to the correct device. You could put the Hub behind the wall where it could control the devices behind the wall, but you would have to run one of the included IR blasters back to the TV. Otherwise it would work in your configuration.
Sorry, there was a problem. Please try again later.Yes, just place the included HUB in the same area as the other devices under the stairs. The remote will communicate with the HUB via RF and then the HUB will communicate with your devices via IR, RF or Wifi.
Sorry, there was a problem. Please try again later.It sends signal by radio frequency (RF) so it will go through walls.
Sorry, there was a problem. Please try again later.Yes, it will work. Our Bose, router, and cable box are around the corner and down the hall in their own closet.
Sorry, there was a problem. Please try again later.Yes! You can place the Hub by the components under the stairs and the remote by the TV. The remote will use Raf to communicate with the hub to control your components and should be able to control your TV from the remote directly.
Sorry, there was a problem. Please try again later.YES. You install the HUB with your components and use the IR extenders if needed also. The remote communicates with the HUB via WiFi and the HUB transmits the commands.
Sorry, there was a problem. Please try again later.Yes. It will easily transmit through an interior wall. As long as your home doesn't have any unusual RF interference.
Sorry, there was a problem. Please try again later.Yes, this is how I have mine set up
Sorry, there was a problem. Please try again later.maybe. Definitely, if you can run one of the IR sensors around the wall.
Sorry, there was a problem. Please try again later.
