“Would this amp power up 4 Kenwood 6x9 4ways at 150 watts rms without overheating?”

1-1 of 1 Answer

• In general, you want to match the continuous output of the amplifier to the nominal power rating of the speakers. The continuous output of the GM-DX874 is about 100 watts to four speaker, with 4 ohm impedance. Check with Kenwood, they can verify the speakers will work properly with 100 watts continuous power.

  Answered by Pioneer Electronics Team 2 years ago

  Helpful (0)Unhelpful (0)

  Report

  Sorry, there was a problem. Please try again later.