“Is there an instruction guide for installing the stacking kit SK-5A?”
Answer This Question
1-2 of 2 Answers
I dont think I found one online. But it is very simple: 1- Lay the dryer on a soft surface on it's SIDE with door closed 2- Install the two plastic slides on the sides of the Dryer bottom. These curve over the top edge of the Washer about the middle side area. 3- Unscrew the legs from the Dryer Lift and slide the dryer on top of the Washer. - *In the final position it will sit back from the front of the washer about 3 inches or so 4- Check which of the 2 pairs of brackets they supply have the holes in the right place by eyeballing them on the back. (You may want to bend the brackets you use into a slightly tighter angle to make the fit a little tighter, it made it easier for me to get the screw started, but its not necessary. I just pushed on it on the garage floor for a second to bend it a little more..) 5- Only start the screws loosely on the Dryer. Then slide the dryer slightly forward until the lower part of the brackets are right on the back of the washer. Wiggle until the holes line up, 6 - Start those screws and then tighten! I put a little foam, under the sharp edges where the front legs came out.
Sorry, there was a problem. Please try again later.The installation instructions for the SK-5A stacking kit are included in the box with the new kit. Thanks for the question, Ms. Samsung
Sorry, there was a problem. Please try again later.