A:AnswerThis amp has no phono pre amp like older models came with but my new Audio Technia table can operate on a standard line input or phono pre amp. Great sounding amp for the money
A:AnswerThis is a good HOME receiver for HOME. It is VASTLY underpowered for a Wharehouse envirement. I would get an amplifier that is designed for commercial use such as DJ equiptment. I would reccomend a 400 watt MINIMUM. You can buy them with USB and Blutooth capability.
A:AnswerFrom what I can tell from the owner's manual, it seems to confirm that this unit can "receive" input from a Bluetooth device but it does not have the capability to transmit to a Bluetooth device such as your headphones. It does have an output jack to accommodate a headphone RCA type plug.
A:AnswerI would return it and get a replacement. Remember...they spent Billions on the space shuttle and still it blew up so you can get a defective receiver right out of the box. Does not mean the whole line is defective.
A:AnswerDual 4 ohm speakers Have to be wired correctly. You can use the sub but it must be wired in THIS manner. You will have 2 positives and two negatives on the speaker. Take one jumper lead and connect one positive on one side to the negative on the other. Then wire the speaker out wires from the amplifier with positive to the positive on the leftover connection and the negative to the left over negative. This is called wiring in SERIES. it will give you 8 ohms and is then safe to run on this amp.
A:AnswerYou can get a HIGH to low impedance adapter. It allows for speaker line level output to be converted to a line level (rca) output.OR you can use connection number 3 out which will work also. It is NOT a dedicated sub out but will work just fine. Keep in mind that any sub adjustments will have to be done at the sub itself. Volume will still be controlled (up and down) by the receiver but it will be up and down with ALL volume. In other words if the sub is too much on one source say TV you will have to balance it at the actual sub so locate it so you can access the controls.
A:AnswerUnplug for several hours and start again. It will reset itself to square zero. While it is unplugged READ your manual again and make sure you know the receivers functions and how to set it BEFORE you attempt to set it up for the second time.
A:AnswerIf I were you i would get a receiver that has both HDMI connections and RCA. This one has only RCA in and out. This receiver is NOT really suited for a home theatre setup but, it can be made to work.
