A:AnswerHi Souci- This is Sue at GE Appliances. Thanks for considering our Unitized Washer and Dryer! Yes, the unit can be converted for use with propane (LP). You can purchase the LP Conversion Kit WE25M74 online at: https://www.geapplianceparts.com/store/parts/spec/WE25M74 - You can also contact our GE Parts Team at 1-877-959-8688, Mon–Fri 8am–7pm, Sat 8:30am–5pm ET. Thanks for checking with us. Enjoy!
A:AnswerHello dryerdoor - this is Nancy at GE Appliances and I am happy to help you. The dryer door on this unitized washer/dryer unit is a right hand door swing only. It cannot be reversed. We apologize for any inconvenience this may cause. Thanks for checking with us!
A:AnswerHi Jmcc- Thanks for choosing GE! We encourage you to view the Installation Instructions for all product dimensions and clearance requirements: http://products.geappliances.com/MarketingObjectRetrieval/Dispatcher?RequestType=PDF&Name=31-16727.pdf - Minimum Clearance Other Than Alcove or Closet Installation: Minimum clearance to combustible surfaces and for air opening are: 0 in. clearance both sides and rear. Consideration must be given to provide adequate clearance for installation and service. On GUD27 unitized washer/dryer units, the dryer is deeper in the rear than the washer. The overhang is 4" past the back panel of the washer, which means it sticks out past the vent, electrical, and plumbing connections. The dryer can sit up against a wall without adding any extra depth to the unit. This provides space for the connections in the rear. Because of this overhang, the unit does not need knockouts to vent to the left or right side. The vent elbow can be turned left, right, or down as needed. Keep in touch! SUE@GEA
A:AnswerHi - Thanks for choosing GE! We encourage you to view the Installation Instructions for all product dimensions and clearance requirements: http://products.geappliances.com/MarketingObjectRetrieval/Dispatcher?RequestType=PDF&Name=31-16727.pdf - Minimum Clearance Other Than Alcove or Closet Installation: Minimum clearance to combustible surfaces and for air opening are: 0 in. clearance both sides and rear. Consideration must be given to provide adequate clearance for installation and service. On GUD27 unitized washer/dryer units, the dryer is deeper in the rear than the washer. The overhang is 4" past the back panel of the washer, which means it sticks out past the vent, electrical, and plumbing connections. The dryer can sit up against a wall without adding any extra depth to the unit. This provides space for the connections in the rear. Because of this overhang, the unit does not need knockouts to vent to the left or right side. The vent elbow can be turned left, right, or down as needed. Keep in touch! SUE@GEA
A:AnswerHi - We are happy to provide assistance! 11 AMP @ 120V. Heater is 4500W, washer motor is 350W; dryer motor is 430W (full load) or 165 W (no load); total load (4500+350+430) = 5280W or 5.280 KW. We hope this is helpful. Keep in touch! SUEatGEA
A:AnswerHi Abe- Thanks for choosing our GE Unitized Spacemaker® Washer/Dryer! We encourage you to view the diagram on page 3 of the Installation Instructions for locations of the water connections and vent: http://products.geappliances.com/MarketingObjectRetrieval/Dispatcher?RequestType=PDF&Name=31-16727.pdf - Thanks for checking with us. Enjoy! SUEatGEA
A:AnswerHi Ric,
I am happy to help. The measurement is 52 7/8 inches from the floor to the bottom opening of the dryer. I hope this helps. Thank you for checking with us. Lisa from GE Appliances.
A:AnswerHi Bob- This is Sue at GE Appliances. Thanks for checking with us! The height to the top of the dryer door is approximately 71-1/2"H (18-5/8" is the door height). We suggest to view the Installation Instructions at the following link for product dimensions (See the bottom of page 3): http://products.geappliances.com/MarketingObjectRetrieval/Dispatcher?RequestType=PDF&Name=31-16727.pdf - Keep in touch!
A:AnswerHi Jim- This is Sue at GE Appliances. Thanks for considering our GE UNITIZED SPACEMAKER® 3.2 DOE CU. FT. WASHER AND 5.9 CU. FT. GAS DRYER GUD27GSSJWW! Gas Rated input is 20,000 BTU/HR. We suggest to view the Quick Specs at the following link for more details: http://products.geappliances.com/MarketingObjectRetrieval/Dispatcher?RequestType=PDF&Name=gud27essjJ_27gssj_c3.pdf - Keep in touch!
A:AnswerHello Kay - this is Nancy at GE Appliances and we are happy to help you. This is a very nice combination washer/dryer unit. It offers a deep rinse option but does not offer separate second rinse option. Thanks for checking with us! We hope this helps!
A:AnswerHello Groot - this is Nancy at GE Appliances and I am happy to help you. The approximate overall exterior dimensions of this washer/dryer combination unit are: 75-1/2 in high x 26-4/5 in wide x 30-17/20 in deep. I hope this helps! Thanks for checking with us!
