
Easily clean and dry your clothing with this GE Unitized Spacemaker GUD27GSSJWW gas laundry center, which features a 3.2 cu. ft. capacity 11-cycle washer and a 5.9 cu. ft. capacity 4-cycle dryer, so you can complete your laundry using a single appliance.
A: This will need clearance for the back hook-ups.
Q: Can this unit be converted to propane?
A: Hi Souci- This is Sue at GE Appliances. Thanks for considering our Unitized Washer and Dryer! Yes, the unit can be converted for use with propane (LP). You can purchase the LP Conversion Kit WE25M74 online at: https://www.geapplianceparts.com/store/parts/spec/WE25M74 - You can also contact our GE Parts Team at 1-877-959-8688, Mon–Fri 8am–7pm, Sat 8:30am–5pm ET. Thanks for checking with us. Enjoy!
Q: How many amps and volts are necessary for this combination? Thank you
A: This uses 20 amps and 120 volts
Q: What material is the washer tub ?
A: The washer tub is plastic, but seems very durable.
Q: can the dryer door be either left or right
A: Hello dryerdoor - this is Nancy at GE Appliances and I am happy to help you. The dryer door on this unitized washer/dryer unit is a right hand door swing only. It cannot be reversed. We apologize for any inconvenience this may cause. Thanks for checking with us!
Q: What is the depth including vent
A: Hi Jmcc- Thanks for choosing GE! We encourage you to view the Installation Instructions for all product dimensions and clearance requirements: http://products.geappliances.com/MarketingObjectRetrieval/Dispatcher?RequestType=PDF&Name=31-16727.pdf - Minimum Clearance Other Than Alcove or Closet Installation: Minimum clearance to combustible surfaces and for air opening are: 0 in. clearance both sides and rear. Consideration must be given to provide adequate clearance for installation and service. On GUD27 unitized washer/dryer units, the dryer is deeper in the rear than the washer. The overhang is 4" past the back panel of the washer, which means it sticks out past the vent, electrical, and plumbing connections. The dryer can sit up against a wall without adding any extra depth to the unit. This provides space for the connections in the rear. Because of this overhang, the unit does not need knockouts to vent to the left or right side. The vent elbow can be turned left, right, or down as needed. Keep in touch! SUE@GEA
Q: What is the depth with vent
A: Hi - Thanks for choosing GE! We encourage you to view the Installation Instructions for all product dimensions and clearance requirements: http://products.geappliances.com/MarketingObjectRetrieval/Dispatcher?RequestType=PDF&Name=31-16727.pdf - Minimum Clearance Other Than Alcove or Closet Installation: Minimum clearance to combustible surfaces and for air opening are: 0 in. clearance both sides and rear. Consideration must be given to provide adequate clearance for installation and service. On GUD27 unitized washer/dryer units, the dryer is deeper in the rear than the washer. The overhang is 4" past the back panel of the washer, which means it sticks out past the vent, electrical, and plumbing connections. The dryer can sit up against a wall without adding any extra depth to the unit. This provides space for the connections in the rear. Because of this overhang, the unit does not need knockouts to vent to the left or right side. The vent elbow can be turned left, right, or down as needed. Keep in touch! SUE@GEA
A: Hi - We are happy to provide assistance! 11 AMP @ 120V. Heater is 4500W, washer motor is 350W; dryer motor is 430W (full load) or 165 W (no load); total load (4500+350+430) = 5280W or 5.280 KW. We hope this is helpful. Keep in touch! SUEatGEA