“i do not kno9w how to set up the descaling process show me how”
Answer This Question
1-2 of 2 Answers
The steps for descaling are: Before you begin, you will need a large ceramic mug, fresh water, descale solution and access to a sink. Do not use a paper cup. STEP 1: FIRST DESCALING SOLUTION RINSE • Turn on your brewer. • Pour one third (4.6 oz.) of the Keurig™ Descaling Solution into the cold Water Reservoir then add fresh water to the 10 oz. fill level. • Place a large ceramic mug on the Drip Tray Plate. Do not use a paper cup. • Lift the Handle but do not add a K-Cup® pod. After 5 seconds, lower Handle and press the BREW button. • Once solution is dispensed, discard hot contents into sink. STEP 2: SECOND DESCALING SOLUTION RINSE • Repeat above process up until you press the BREW button. • When BREW button turns solid red, power off as it starts to dispense. • Let brewer stand for at least 30 minutes. • Power on the brewer, lift and lower Handle, then press BREW button. • Discard the hot contents into sink. STEP 3: FRESH WATER RINSE • Repeat Step 1 (3 times) – using 10 oz. of fresh water each time. • You may need to perform additional Fresh Water Rinse cycles if you notice any residual taste.
Sorry, there was a problem. Please try again later.Pour white vinegar into water resevoir. Run 2 to 3 times. Then switch back to regular water and run a few times.
Sorry, there was a problem. Please try again later.