“I have 4 TV's wired for cable & trying to switch to antenna. Purchased RF-G1179 splitter. Installed antenna & plugged antenna cable into INPUT, & connected power. When I disconnect first TV cable wire & plug into output can't scan any channels no signal??”

1-3 of 3 Answers

• it looks like you are doing a first time ota tv antenna , either indoor or outdoor ,, you may need to point your antenna to transmitting tower .. and get a signal ,, if weak , then the amp will boost the signals .. if you have no signal the amp will do nothing ..

  Answered by Controler 7 years ago

  • Verified Purchase
  • 
  • Top 1000 Contributor

  Helpful (0)Unhelpful (0)

  Report

  Sorry, there was a problem. Please try again later.

• You might want to Set up your Antenna first by Turning it toward your Nearest TV Stations Tower to get a Signal First then add your other TVS

  Answered by Will 7 years ago

  • Verified Purchase
  • 

  Helpful (0)Unhelpful (0)

  Report

  Sorry, there was a problem. Please try again later.

• Disconnect all TVs. Then attach booster to the antenna. Then attach 1 tv. Scan. Then connect another tv and scan. If it doesn’t work then connect 1 tv at a time and scan each tv. When finished connect all tvs

  Answered by Merry 8 years ago

  • Verified Purchase
  • 

  Helpful (0)Unhelpful (0)

  Report

  Sorry, there was a problem. Please try again later.