“Bluetooth enabled turntable won't connect to any blue tooth speaker. We tried three separate speakers that connect easily to other electronics. Please advise.”
Answer This Question
1-2 of 2 Answers
I I don't use bluetooth im old school
Sorry, there was a problem. Please try again later.Try resetting the Bluetooth on the turntable. Note that the reset procedure was recently amended. Right after you press the Bluetooth button and the light starts flashing red/blue, let go of the button for 1 second then press and HOLD it down until you see the light flash just RED slowly twice. See the full procedure, step by step, below. Resetting the Bluetooth on the AT-LP60XBT and AT-LP120XBT-USB-BK Turntables. 1. Power off your Bluetooth audio device (speaker, headphone or sound bar). Turn any other devices that have previously been paired to the turntable off (power them down). 2. Place the turntable and your Bluetooth device within 3 feet of each other. Keep the turntable and the device away from other wireless devices, particularly Wi-Fi routers and/or extenders, computers with USB 3.0 ports, and microwave ovens. 3. Press and hold down the Bluetooth button on the turntable for about 2 to 3 seconds. You will see the light begin to flash red and blue rapidly back and forth as it does when it goes into the pairing mode. After about 1 to 2 seconds of seeing this, briefly release the button (for about 1 second) then press and hold the button down until you see the light blink just RED slowly - twice, then the light will go back to flashing red and blue. It may take up to a minute or so to see the light blink just RED twice. Once the light goes back to flashing red and blue, you may let go of the button. 4. Wait for the flashing red and blue light to time out, at which time it will go back to being solid red. This may take up to a minute or so to occur. Once the light is solid red, the Bluetooth function on the turntable has been reset. 5. Power on your Bluetooth device and attempt to pair the turntable to it again.
Sorry, there was a problem. Please try again later.