“the rubber came off from the turntable. how do I get it back on.”
Answer This Question
1-1 of 1 Answer
Remove the record mat from the turntable. Remove the platter from the center spindle as shown in Figure 11c. Once removed, flip the platter over and note the raised rim located about an inch and a half in from the outer edge of the platter. The belt goes around this rim. See Figure 11d. Make certain that the belt lies flat (no twists) all the way around the rim. Once the belt is installed around the rim, flip the right side side up and place it back on the center spindle. Rotate the platter by hand until one of the large rectangular shaped openings is located at the upper left corner of the turntable (at about the 10 o’clock position). Look into the opening and locate the brass colored motor pulley. Grab the belt with your fingers and stretch it over the pulley. The belt will be located at the inside edge of the rectangular shaped opening. Place the record mat back on the turntable, place a record on the mat and test for normal operation.
Sorry, there was a problem. Please try again later.