“everthing hooked up right but acts like it isn,t getting power , checked and getting power to everthing else.”
Answer This Question
1-1 of 1 Answer
Check the belt routing. The belt comes preinstalled around the drive rim on the flipside of the aluminum record platter (see below), but you have to finish installing it by placing it around the motor pulley after installing the platter on the spindle. Make certain that you are placing the belt around the brass-colored motor pulley after installing the platter. To check this, simply remove the black felt record mat from the turntable and rotate the aluminum record platter by hand until one of the large rectangular shaped openings in the platter is located in the upper left corner of the turntable (at about the 10 o’clock position). Look into the opening and locate the brass colored motor pulley. Is the belt around this pulley and is the belt taught? The belt does NOT go around the white post located on the right side of the turntable (at about the 2 o’clock position).
Sorry, there was a problem. Please try again later.
