“I mounted the detector as instructed on the windshield. The next time I got into my car it was on the floor along with the suction cup (I hadn’t even gone anywhere yet). How do you get it to stay on the windshield? Is there a better way to mount it? TY”
Answer This Question
1-4 of 4 Answers
Yes, get a blend mount.
Sorry, there was a problem. Please try again later.When placing the mount for the "360" on the windshield, make sure to remove the white "protector" from the suction cup itself. Once that liner is removed, press the cup up against the glass until it is flat, then flip the suction lever down to create a vacuum. Once this is done there should be no problem with adhesion of the bracket to the windshield. If so, either the suction cup or windshield is dirty or the cup is bad. In fact it might be a good idea to wipe the surface you are attaching the device too with a bit of denatured alcohol before placing the cu n it just to be sure!
Sorry, there was a problem. Please try again later.If the StickyCup is no longer sticky, it has acquired debris. Simply rinse the StickyCup with water and rub the debris off with your fingers. Shake it dry. Do not use a towel or you will re-apply debris. Afterwards it should be sticky again and mount solidly to your windshield.
Sorry, there was a problem. Please try again later.I cleaned the area on the windshield well before I attached the suction cup. I put just a little bit of water (just enough to make it damp) on the suction cup, stuck it to the windshield and then snapped that little black switch to lock into place. I haven't had any issues with mine coming off. Hopefully this will answer your question or at least assist.
Sorry, there was a problem. Please try again later.