“I need measurement from floor to center of vent pipe on back of unit and also from each side.”
Answer This Question
1-2 of 2 Answers
51 inches is the measurement I got for vent pipe side to side on is 27 inches
Sorry, there was a problem. Please try again later.Hi Rog- The dryer is deeper in the rear than the washer. The overhang is 4" past the back panel of the washer, which means it sticks out past the vent, electrical, and plumbing connections. The dryer can sit up against a wall without adding any extra depth to the unit. This provides space for the connections in the rear. Because of this overhang, the unit does not need knockouts to vent to the left or right side. The vent elbow can be turned left, right, or down as needed. See page 2 of the Installation Guide for product dimensions including vent location. Also, see page 15- BOTTOM OR SIDE VENTING: https://products.geappliances.com/MarketingObjectRetrieval/Dispatcher?RequestType=PDF&Name=31-16781-3.pdf - Keep in touch! SUE@GEA
Sorry, there was a problem. Please try again later.